Serial NO. : S00305054-EN
Date of Editing : 2022-11-14
Questions : Why it shows “M59 Card Inhibited” in 701ClientSQL after card presentation?
Demonstration:
There are three reasons may cause “M59 Card Inhibited” appear in 701ClientSQL:
1. Forgot to setup the access function after adding a valid card
2. The user address or card had been suspended
H series controller / E series touch keypad controller:
E series LCD controller:
Enter program mode > 1. Add / Delete > 3. Suspend – Address
Enter program mode > 1. Add / Delete > 4. Suspend –ID
Enter program mode > 1. Add / Delete > 7. Recover - Address
Enter program mode > 1. Add / Delete > 8. Recover - ID
※In actually, the access mode will be modified to “invalid” after the card or address be suspended, therefore, reason (1) and (2) are the same thing. We could find that the access mode will be modified to invalid after suspending a card on controller.
3. The function of “Enable the RF after door sensor closed to GND” has been enabled
H series controller built-in a specific function that using GND to control card reading, it is usually been used in parking lot vehicle access.
